Specifications; Installation And Transport - Casals CTR305 Bedienungsanleitung

SPECIFICATIONS

Voltage
Power
Protection Class
Degree of protection
Saw blade speed
Saw blade diameter
Dimensions (machine in packaging)
Maximum work piece cross section
0º x 90º
45º x 90º
0º x 45º
45º x 45º
Cutting capacities in the table saw
Gross Weight
Net Weight: (it must include all accessories)
Sound power Level L
WA
(according ISO 3744)
Sound pressure level at operator L
(according ISO 3744)
Effective value of weighted acceleration (vibration at handle)

INSTALLATION AND TRANSPORT

- Remove the box used to protect the machine
during transport and keep it intact for future
transport or storage.
- CAUTION Do not carry the machine by the han-
dle; the handle is not designed to bear the entire
weight of the machine. To carry the machine,
hold it on both sides of the base (12).
INSTALLATION (FIG.14)
- Lift the machine out of the box with the help of
another person.
- Turn rotating table into 0º position and tighten
the mitre lock.
- Note: If the machine is to be mounted on a
workstand, do not install the rubber feet.
- To install the rubber feet, carefully turn the
machine over to the right, so it is supported by
the motor.
- Fit the nut (A3) into the hole on the bottom of
the rubber foot.
- Insert the Allen head screw (A1) into the ma-
chine's foot from the top. Attach the rubber foot
(A2) with the previously inserted nut (A3) to the
screw.
PA
- Tighten the rubber foot hand-tight only.
- Tighten screw with the Allen key hand-tight only.
- DANGER! Risk of injury by incorrect handling
when lifting the machine or turning the machine
over. Always hold machine at the base (12).
- Place machine on a suitable surface:
- All four feet must firmly rest on the surface.
- The ideal height for the surface is approx
.800mm.
- The saw must stand securely, even when cut-
ting larger work pieces.
- Keep the packaging for future use, or separate
by material and dispose of in an environmentally
friendly manner.
TRANSPORT (FIG.5, 12, 13)
- Place the lower blade guard (14) from the left
hand side in front of the kerf plate's rear end
and push towards the rear.
- Swing sawhead down and engage the lock
down pin (22).
- Place the rip fence over the blade guard and
secure in position
- Lift the machine by holding it on both sides of
the base (12).
220-240 V~
S1 1600 W S6 25% 1800W
II
IP20
4000 min
-1
305 mm
710 x 585 x 470 mm
100x170 mm
100x118 mm
67x170 mm
62x62 mm
52 mm
26.5 Kg
22 Kg
105,5 dB(A)
92.5 dB(A)
1.74 m/s
2