Casals CTR305 Bedienungsanleitung Seite 9

working in table saw mode.
- Do not jam work pieces.
- Make sure the saw blade is suitable for the work
piece material.
- Cut thin or thin-walled work pieces only with
finetoothed saw blades.
- Always use sharp saw blades.
- If in doubt, check work piece for inclusion of
foreign matter (e.g. nails or screws)
- Cut only stock of dimensions that allow for safe
and secure holding while cutting.
- Never cut bundes or more than one work pieces
at a same time the individual pieces cannot be
properly secured and controlled. Risk of person-
al injury if individual pieces are caught by the
saw blade uncontrolled.
- Never attempt to cut any work pieces which
contain: ropes, strings, cords, cables or wires,
or to which any of the above are attached.
- Minimize the amount of wood dust escaping
from the machine and the job site to the envi-
ronment. (Remove wood dust deposit, fix any
leakages on the dust collector, ensure good
ventilation...)
- Make sure the riving knife is not bend. A bent
riving knife will push the work piece against the
side of the saw blade, causing noise.
SERVICE
- This electric tool complies with the relevant
safety rules. Repairs should only be carried out
by qualified persons using original spare parts,
otherwise this may result in considerable danger
to the user.
DESCRIPTION
1- Upper saw table
2- Riving Knife
3- Blade guard
4- Rip Fence
5- Tip Fence Knob
6- Safety lock
7- ON/OFF Switch
8-Switch A
9- lock knob
10- Miter angle scale display
11- Miter table
12- Baseplate
13- Fende
14- Lower blade guard
15- Scale
16- Bevel locking lever
17- Scale
18- Blade
19- Sawhead
20- Trigger
21- Kerf plate
22- Lock down pin
24- Push Stick
25- Work clamp
26- Hexagon spanner
28- Dust bag
29- Switch B
If the model of your appliance does not have the
accessories described above, they can also be
bought separately.