Electrical Connection - WIKA TF35 Betriebsanleitung

5. Commissioning, operation

5.2 Electrical connection

DANGER!
Danger to life caused by electric current
EN
Upon contact with live parts, there is a direct danger to life.
▶
▶
▶
▶
▶
Fine-stranded leads must be finished with end splices.
■
Cables used must comply with the respective requirements in terms of stability and
■
temperature.
Connection cables must be run so that any mechanical damage is prevented.
■
Only connect circuits with the same voltage and type of protection to the switch
■
contacts and connection leads of the instrument.
Size the connection leads for the largest current in the circuits.
■
Only connect the TF35 with extra-low voltage circuits, or with safety extra-low voltage
■
circuits (SELV) or protected extra-low voltage circuits (PELV).
Do not connect circuits simultaneously with low-voltage circuits.
■
Pin assignment
AMP Junior Power Timer connector
Deutsch instrument connector DT04-2P
12
The instrument may only be installed and mounted by skilled
personnel.
Operation using a defective power supply unit (e.g. short-circuit from
the mains voltage to the output voltage) can result in life-threatening
voltages at the instrument!
Only connect with the voltage disconnected!
Only disconnect the mating connector with the voltage disconnected.
Use suitable mating connectors for the current and voltage ranges.
FASTON blade terminal
Bayonet connector per DIN 72585
WIKA operating instructions model TF35