Safety Instructions - HBM SD01A Bedienungsanleitung

4
SD01A

Safety instructions

Use in accordance with the regulations
The Zener barrier is to be used exclusively for measurement tasks and
directly related control tasks. Use for any purpose other than the above shall
be deemed to be not in accordance with the regulations.
To ensure safe operation, the device may only be operated in accordance with
the information given in the Operating Manual. It is also essential to comply
with the legal and safety requirements for the application concerned during
use. The same applies to the use of accessories.
General dangers of failing to follow the safety instructions
The Zener barrier corresponds to the state of the art and is fail-safe. The
device may give rise to remaining dangers if it is inappropriately installed and
operated by untrained personnel.
Any person instructed to put the equipment into service must have read and
understood the Operating Manual and in particular the technical safety
instructions.
Remaining dangers
The scope of performance and supply of the Zener barrier covers only part of
the range of measurement technology. In addition, equipment planners,
installers and operators should plan, implement and respond to the safety
engineering considerations of measurement technique in such a way as to
minimize remaining dangers. Prevailing regulations must be complied with at
all times. There must be reference to the remaining dangers connected with
measurement technique.
Any risk of remaining dangers when working with the Zener barrier is pointed
out in this manual by means of the following symbols:
WARNING
Symbol:
Meaning: Dangerous situation
Warns of a potentially dangerous situation in which failure to comply with
safety requirements can lead to death or serious physical injury.
HBM A1045−2.4 en/de/fr