Function Buttons - Kaisai OSK 102 Bedienungsanleitung

Function Buttons

Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use The Basic/Advance Functions section of
this manual.
NOTE：Please do not select HEAT mode if the machine you purchased is cooling only
type. Heat mode is not supported by the cooling only appliance.
ON/OFF
Turns the unit on or off
MODE
Scrolls through operation
modes as follows:
AUTO g COOL g DRY g
HEAT g FAN
ECO
Starts and stops energy
efficient feature. If hold
down this button for
more than 2 seconds,
the sleep feature is
activated.
TIMER
Sets timer to turn unit on
and off(see How to Use
Basic Functions for
instructions)
LED
,
Turns indoor unit s LED
display on and off.
FOLLOW ME
Temperature sensing and
room temperature display
button.
TURBO
Enables unit to reach
preset temperature in
shortest possible time.
If hold down this button
for more than 2 seconds,
the Fresh feature is
activated.
Mode ON/OFF Fan
Timer Timer
Follow
LED
me
Self
Short
Turbo
clean
cut
SHOUT CUT
Sets and activates your
favourite pre-settings.
3
72
FAN
Selects fan speeds in
the following order:
AUTO g LOW g
MED g HIGH
NOTE: Holding this button
down for 2 seconds will
activate Silence feature.
TEMP
Increases temperate in
1 C increments. O
Max. temperature is 30 C.
TEMP
Decreases temperate in
1 C increments. O
Min. temperature is 17 O
SWING
Used to stop or start hori-
zontal louver movement
or set the desired up/down
air flow direction. The louver
changes 6 degree in angle
for each press. If keep
pushing more than 2
seconds, the louver will
swing up and down
automatically.
SWING
Used to stop or start vertical
louver movement and set the
desired left/right air flow
direction. The vertical louver
changes 6 degree in angle
for each press. If keep
pushing more than 2 seconds,
the vertical louver auto swing
feature is activated.
SELF CLEAN
Starts and stops the unit
self clean feature.
O
C.