Electrolux ERF4113AOW Benutzerinformation Seite 27

6.1 What to do if...
Problem
The appliance is noisy.
The compressor operates
continually.
Water flows inside the re‐
frigerator.
Water flows on the floor.
The temperature in the
appliance is too low/too
high.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easi‐
ly.
Possible cause
The appliance is not sup‐
ported properly.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The water outlet is clog‐
ged.
Food products prevent
water from flowing into
the water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
Many food products were
stored at the same time.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not
wrapped.
You attempted to re-open
the door immediately after
closing.
ENGLISH
Solution
Check if the appliance
stands stable.
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of the
door.
27