Installation Instructions - Cavist CAVIST91 Gebrauchsanweisung

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source,
let it stand upright for approximately 4 hours. This will
reduce the possibility of a malfunction in the cooling system
from improper handling during transportation. Clean the
interior surface with lukewarm water using a soft cloth.
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and
should not be recessed or built-in.
Allow 5 inches of space between the back and sides of the
wine cooler, which allows the proper air ventilation. Adjust
the feet to keep the wine cooler level. Locate the wine
cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical
consumption. Ambient temperature below 5°C or above
32°C will hinder the performance of this appliance.
Depending on the location of the appliance, the direction of
the door opens can be changed.
This unit is not designed for use in a garage or any other
outside installation.
Avoid locating the wine cooler in moist areas.
Plug the wine cooler into dedicated, properly installed-
grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized
service center.
This unit is not designed to be installed in an RV or used
with an inverter.