Reversing The Door Swing - Cavist CAVIST91 Gebrauchsanweisung

Once opened, wine will remain in a drinkable condition for two days for delicate whites or three
o
days for rich reds, as long as the bottle as been resealed. You should make sure that the seal is firm
by checking the stopper.
Special stoppers that keep wine sparking and Champagne bubbling for one or two days after
o
opening, can be bought at most good wine shops.
When stored correctly, white wines can keep well for up to two years. Full bodied reds will age
o
well for ten years and dessert wines will age well for up to twenty years.
When you buy a bottle of wine, you should transfer it to a suitable storage location immediately
o
(if you are not going to store it in your wine cooler).
Cheaper bottles of wine will not age as well as more expensive ones.
o
To make the most of the bouquet and taste of your wine, never fill more than half a glass at a
o
time. It will also help if
the shape of your wine glass is appropriate for your wine. The size and shape of your wine
o
glass's bowl will determine the intensity and complexity of the bouquet. The stem should be long
enough to allow you to avoid hand contact with the bowl of the glass and should be tulip-shaped or
tapered at the top.

REVERSING THE DOOR SWING

This unit has the capability of either opening the door from the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reserve the
opening direction, please follow these instructions:
Note: Before reversing the door, the power must be shut off. All parts removed must be saved to
to the reinstallation of the door.This unit has been built with the door hinges on the right. If you
wish to change the opening direction, follow the instructions below:
1. Remove the upper hinge cover (6) first.
2. Remove the three screws (1)that hold the upper hinge(5) (right side) to the frame, Take away the
upper hinge(5) (right side).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (8) that hold the lower hinge(2) and make sure to remove the lower
hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate (7) to the right side.
7. Before placing this lower hinge(2),remove the bolt in(9) and reverse the direction of the lower
hinge(2).Then install the lower hinge(2) onto the left side of the lower frame with two screws.
8. Insert the bolt in(9) to the lower hinge(2).
9. Set the door to its place making sure the door seat at the lower hinge (2).
10. While holing the door in the closed position secure the upper hinge (5) in the top frame of left
side with three screws(1).Please remember that do not tighten the three screws(1) until the top
of the door is leveled with the counter top.
11. Install the upper hinge cover (6) on the upper hinge.