Desoutter ELRT Serie Bedienungsanleitung Seite 12

6159939064_01
To reach the best performance, we recommend
to set the CVIL II controller parameters as
follows:
Type
Parameters
of joint
Speed
Hard
Pulse amplitude
Speed
Soft
Pulse amplitude
Decrease
No
speed
by 10%
too low
Decrease
pulse amplitude
by 10%
INSTALLATION
● See page 9.
Do not use the tool with total cable length
above 30m.
Tool must be used with its protective
cover on.
STANDARD TOOL DESCRIPTION
A
1 Ouput
2 Trigger
3 Reverse
4 LEDs
Target torque
Min. Max.
% 20 40
% 40 70
% 100
% 100
Tighten your application
Final torque
≥
target torque
Yes
Pulses are displayed
on CVIPC or on
controller display
Yes
too high
Number
of pulses
OK
Setup OK for the joint
12 / 96
Increase
No
pulse amplitude
by 10%
Yes
Speed < 100%
No
Increase
speed
by 10%
Increase
pulse amplitude
by 10%
09/2019
English