Installation; Location; Rear Spacers; Shelf Holders - Electrolux ST 401 CNN Benutzerinformation

78 electrolux

INSTALLATION

Location

The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely
around the back of the cabinet. To
ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the
cabinet and the wall unit must be at
least 100 mm . Ideally, however, the
appliance should not be positioned
below overhanging wall units. Accurate
levelling is ensured by one or more
adjustable feet at the base of the
cabinet.
NP005
Attention
It must be possible to disconnect the
appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.

Rear spacers

In t t he a a ppliance, t t here a a re t t wo s s pacers
which m m ust b b e f f itted a a s s s hown i i n t t he
figure . .
Slacken the screws and insert the
spacer under the screw head, then re-
tighten the screws.

Shelf holders

Your appliance is equipped with shelf
retainers that make it possible to
secure the shelves during
transportation.
To remove them proceed as follows:
Move the shelf holders in the direction
of the arrow, raise the shelf from the
rear and push it forward until it is freed
and remove the retainers.
A
B
C