Herunterladen Inhalt Inhalt Diese Seite drucken

Installation - Electrolux ENB38807X Benutzerinformation

Kühl - gefrierschrank
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

20 electrolux

INSTALLATION

Caution! Read the "Safety Information"
carefully for your safety and correct operation
of the appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambi-
ent temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by
one or more adjustable feet at the base of the cab-
inet.
Warning! It must be possible to disconnect
the appliance from the mains power supply;
the plug must therefore be easily accessible after
installation.
A
B
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
The appliance must be earthed. The power supply
cable plug is provided with a contact for this pur-
pose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting
a qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
Slacken the screws and insert the spacer under
the screw head, then tighten again the screws.
3
Levelling
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front.
2
1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis