Philips SRU 3003 Bedienungsanleitung Seite 39

Problem
The 'ready
to flash'
light does
not go on
when I place
the body
attachment
on my skin,
but the
cooling fan
works.
The 'ready
to flash' light
is green but
the appliance
does
not produce
a flash when
I press the
flash button.
The
appliance
becomes
warm during
use.
Possible
cause
The safety
ring is dirty.
The overheat
protection
has been
activated.
The
appliance
needs to be
reset.
This is
normal.
Solution
Clean the safety ring carefully. If you
are unable to clean the safety ring
properly, contact the Consumer Care
Centre in your country, your Philips
dealer or a Philips service centre to
replace the flash screen.
When the overheat protection has
been activated, the fan still works. Do
not switch off the appliance and let
it cool down for approx. 15 minutes
before you continue to use it. If the
'ready to flash' light still does not go
on when you place the appliance on
the skin, contact the Consumer Care
Centre in your country, your Philips
dealer or a Philips service centre.
To reset the appliance, switch off the
appliance and switch it on again. If the
'ready to flash' light is green but the
appliance still does not produce a
flash when you press the flash button,
contact the Consumer Care Centre in
your country,
your Philips dealer or a Philips service
centre.
No action required.
English
39