Philips SRU 3003 Bedienungsanleitung Seite 26

English
26
B Let go of the flash button after each flash.
For the next flash, place the appliance on the area
right next to the previously flashed area. Make sure
the safety ring is fully pressed onto the skin.
This 'Step & Flash mode' guarantees a precise
treatment of e.g. the knees or ankles.
Note: After a few seconds, the appliance is ready to
flash again, so make sure that you move it to the next
area immediately after it has flashed.
Do not treat exactly the same area multiple times
during one session. This does not improve the
effectiveness of the treatment, but increases the
risk of skin reaction.
Note: The visible light produced by the appliance is the
reflection of the flash on the skin and is harmless to your
eyes. It is not necessary to wear goggles during use.
8 To avoid untreated areas, always make
sure there is some overlap with the previously
treated area when you place the appliance on
the skin.The effective light only comes out of
the light exit window with integrated UV filter.
Make sure the flashes are produced close to
each other. Ask somebody else to help you
with the treatment if you want to treat your
back to ensure that the treated areas overlap.
9 Switch off the appliance after you have finished
the treatment.
10 Check the body attachment and light exit
window for hairs and dirt and clean the
appliance after use. See chapter 'Cleaning and
maintenance'.