Panasonic TY-WK70PV50 Montageanweisungen Seite 24

Fitting procedure
Using the positioning pads adhered to the wall as
guidelines, align the top of the display at the left and
right.
Engage the insulation spacers at the top of the
display with the cutouts at the top of the bracket
unit, and slowly lower them into place.
While lifting the display slightly, insert the bottom
insulation spacers into the holes at the lower end of
the wall-hanging bracket, and then pull the display
straight down into place.
CAUTION
• If the display is lifted too much, its top part will become
disengaged from the wall-hanging bracket.
Pull the display towards you, and fasten completely
the screws for securing the unit
side) which were temporarily fastened in
(Tightening torque: 1.2 to 1.5 N•m)
Notes
• To prevent the display from coming off the wall, make sure that the screws for securing the
unit are screwed in all the way and ¿ rmly tightened.
• Do not pull out the display more than necessary. Otherwise it may contact and damage the wall.
Move the display back in the vertical position.
Push the center of the bottom part of the display and mount the display vertically on
the wall.
• Gently pull the display towards you to con¿ rm that it has been locked.
• After tightening the screws for securing the unit
not move up.
WARNING
When there are people in the nearby area, do not move the display back and forth.
• Their ¿ ngers or hands may be caught between the display and the wall or the bracket resulting
in injuries.
CAUTION
Be careful not to have your ¿ ngers pinched during installation work.
• It can cause injuries.
24
(one screw on each
in the step 4.
, lift the display to con¿ rm that it does
Cutout at top
Insulation spacer at top
③
Hole at
bottom
④
Insulation
spacer at
bottom
Screw for securing the unit
Screw for securing the unit