Panasonic TY-WK70PV50 Montageanweisungen Seite 23

4. Temporarily fastening the screws for securing unit
Temporarily fasten (2 to 3 turns) the screws for securing unit
base right and left ¿ ttings.
Horizontal installation: Temporarily fasten the M5×570 (long) screws (2) in the screw
Vertical installation: Temporarily fasten the M5×240 (short) screws (2) in the screw
Horizontal installation
Screws for securing unit (long) (2)
5. Installing the insulation spacers onto the display
Place the display face down on a clean blanket
or other piece of fabric free from dirt and foreign
matter, and proceed as instructed below.
Take care to prevent scratches or damage if the
display has protruding parts.
Use a Phillips head screwdriver to remove the caps
(4) from the display.
Note
• Keep the caps which have been removed in a safe place.
(They will be required when a separate installation stand is used.)
As shown in the ¿ gure on the right, install the accessory
Allen head countersunk screws
washers and insulation spacers
using included allen wrench
the caps were previously installed.
Tightening torque for the M8 screws: 3 to 4 N•m
• Use the Allen head countersunk screws
the screw holes (M8) in the display.
6. Attaching and securing the display to the
wall-hanging bracket
Wire the power cord and the connected devices.
Vertical installation
Turn the display unit 90° to the right so that the
Panasonic logo comes to the left, and attach it in
the same way as landscape mounting.
• Make sure that the power cord and the cables of
connected devices are not caught by the wall and ¿ ttings.
Note
• Carry out the wiring so that, even if the display is moved
back and forth, the power cord and cables are not caught in
the wall-hanging bracket.
holes on the lower sides of the base right and left ¿ ttings.
holes on the lower sides of the base right and left ¿ ttings.
, dished toothed
(x4 for each part)
at the locations where
in the screw holes of the
Vertical installation
Screws for securing
unit (short) (2)
* Appearance of the display differs
according to the model. The
¿ gure below is an example of an
applicable model.
A blanket, etc. Cap
that ¿ t in
A blanket, etc.
Phillips head screwdriver
23