Panasonic TY-WK70PV50 Montageanweisungen Seite 20

Components
Parts used to assemble the wall-hanging bracket
Base upper ¿ tting (1)
Model nameplate
Base lower ¿ tting (1)
View of fully assembled
fixture
The images shown in this manual are for illustrative purpose only.
The product speci¿ cations may be changed at any time without prior notice.
Precautions for wall-hanging bracket ¿ tting
The wall-hanging bracket is for use in attaching a display unit to a vertical wall for viewing. Do not ¿ t to any
surface other than a vertical wall.
To ensure correct display performance and prevent trouble, do not ¿ t at any of the following locations.
• Near sprinklers or ¿ re/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
Fit using techniques suited to the structure and materials of the ¿ tting location.
Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are ¿ tting the bracket to.
For the display power supply plug, use a power supply outlet that can be reached easily.
Ensure good air À ow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the display, resulting in malfunction.
Spread a soft blanket or cloth over the À oor so that the display and À oor will not be marked or scratched
during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insuf¿ ciently tightened nor over tightened.
Take suf¿ cient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
Do not install the display underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the cabinet
may be bent or damaged by high heat.
To the Installation Contractor
If the wall-hanging bracket installation and display installation work are performed by different contractors,
please ensure that this manual is passed from the wall-hanging bracket installation contractor to the display
installation contractor after the wall-hanging bracket installation work is complete.
Please give this manual to the customer after the installation work is completed.
20
Bracket base left
¿ tting (1)
Parts used for installation
Allen head countersunk
screws
Dished toothed washers (4)
Insulation spacers (4)
Bracket base right
¿ tting (1)
Screws for securing unit
M 8×32 (4)
Positioning pads (2)
Allen wrench (included
tool)
Screws for
assembling the ¿ xture
M4×8 (8)
M 5×570 (Long) (2)
M 5×240 (Short) (2)
(1)