Operation - Foster 7316000 Bedienungsanleitung

Time limit device
SAFETY FUNCTION AND ERROR SIGNALS
The cooker hob is equipped with sensors to protect it against overheating. If overheating occurs, the cooking zones
closest to the control panel turn off.
ERROR
CODE
Continuous activation of the sensors (BUTTONS)
ER03 +
for more than 10 seconds, due to the presence of
continuous
objects or liquids on the glass in the touch-control
buzzer
area.
U400
ER20
ER21
Contact the authorised technical assistance centre - specify the error code
ER22
ER36
ER40

OPERATION (7352010)

Control knobs
Residual heat indicator
In order to ensure greater safety during operation, the cooker hob is equipped with a time
limit device (for each single cooking zone). The operating time depends on the last heat
setting selected.
If the heat setting is not modified for a long period, the cooking zone turns off
automatically after a certain period of time that depends on the selected heat setting (see
table below).
Heat setting
Maximum time (h)
ERROR DESCRIPTION
The cooking zones are controlled by knobs that turn clockwise and are connected to an
energy regulator. The numbers 1 to 8 indicate the various heat settings: 1 is the lowest
heat setting and 8 the highest, while 0 corresponds to the "off" mode.
The cooking zone controlled by each knob is visualised in the identification diagram
adjacent to each knob.
Control knob
A.
Residual heat indicator
B.
Cooking zone identification diagram
C.
Cooking zone
D.
Each heating element is associated with a residual heat indicator that automatically turns
on once the corresponding cooking zone has reached or exceeded a temperature of
50°C. Once the cooking zone is turned off, the relative light remains lit until the cooking
zone cools down to below 50°C.
1 2 3 4 5
6 6 5 5 4
Dry off the water and remove the objects from the
sensor surface. If the problem persists, contact the
authorised technical assistance centre - specify the
error code
21
6 7 8 9
1,5 1,5 1,5 1,5
REMEDY