G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER LWG 12 Betriebsanleitung

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LWG
12.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machines are intended for the purpose of cutting,
roughing and brushing of metal and stone materials.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
07/2019. M. Voyame/Managing Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 f
itting of hose couPling
Fitting of hose coupling inside diameter min. 7mm (avail-
able as optional accessory, item no. 90805700).
20
s
otes on aFety
ommIssIonIng
2.2 t

AKing the mAchine into serVice

2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level EN ISO 15744 81dB(A), K=3dB(A)
Noise emission level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o

PerAting conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 P
rotectiVe deVices
The machine may only be operated with
the safety guards and the additional han-
dle fitted!
max. 6.3bar
900W
1.1m /min
3
0.6m /min
3
about 2-3 drops/min
12000min
-1
125mm
M14 / 5/8"
92dB(A), K=3dB(A)
7.8m/s , K=2.6m/s
2 2
3/4/4
1.7kg
/ o
PeratIon