Printer Requirements; Ribbon Requirements; Everest 400 Ribbons; Label Design Requirements - Rimage Professional 3400 Bedienungsanleitung

Important Information

Printer Requirements

This section describes ribbon, label design, and print requirements for the
integrated Everest 400 printer.

Ribbon Requirements

Important!
Rimage only supports the use of Rimage brand ribbons in our printers.
•
Printer issues that occur as a result of using ribbons from manufacturers
other than Rimage are not included under your Rimage warranty or
maintenance agreement.
For optimum results, make sure that Everest ribbons are stored at a
•
temperature between 41° and 95°F (5° to 35°C) and humidity level
between 45% and 85%.
Avoid moisture and direct sunlight.
•
Do not reuse ribbons.
•
Use only ribbons designed for your Everest 400 printer. Refer to the
•
table below.
The integrated Everest 400 printer requires a print ribbon and a retransfer
ribbon. The standard print ribbon has three colors: Cyan, Magenta, and
Yellow (CMY). These three colors combine in printing to create full-color
discs. Print ribbons are also available in black (monochrome) and Cyan,
Magenta, Yellow and White (CMY+W, 5400N only).

Everest 400 Ribbons

Ribbon Type
3-color (CMY)
4-color (CMY+W), 5400N only
Black (monochrome)
Retransfer ribbon
2001431_C
All manuals and user guides at all-guides.com
Number of Discs Printed
500
325
1000
500
For more information visit

Label Design Requirements

The Rimage Windows-compatible software ships with the CD Designer™
label editor. CD Designer is installed on the embedded or non-embedded PC
during a typical installation of the Rimage software and is used for designing
labels for printing with the integrated Everest 400 printer. CD Designer can
be used to design labels on any Windows-based PC.
• File format – For best results, save your labels as JPEG or TIFF files.
However, these file formats must be imported into CD Designer and
saved as CD Designer files (.btw) or converted to PDF files before
printing.
• Color mode – Convert all labels to the RGB color mode in order to
import them into CD Designer.
• Resolution (pixels per inch) – For best results, use images set to a
minimum of 300 pixels per inch. You may notice better results if you use
images with 600 pixels per inch or higher.
• Label design size – Design labels with
a height of 12 cm and width of 12 cm.
A full-size disc is 120 mm (4.723") in
diameter. The hole is 15 mm (0.59")
The printable area and hub sizes vary
depending on the disc manufacturer.
Tip: The media that are in Rimage Media Kits have a printable area of 118-24
mm. On most labels, print settings of 118 mm and 24 mm are
recommended.

Print Requirements

Any label you create and save through CD Designer is in the correct file
format (.btw) for printing to the integrated Everest 400 in the 3400 and
5400N system. You can also print labels saved as PDF files.
rimage.com/support
Printable
Area 118 mm
Hub Size
24 mm
6