Install The Print Ribbon - Rimage Professional 3400 Bedienungsanleitung

Change the Print and Retransfer Ribbons
3. Remove the used print ribbon from the carrier.
a. Lift up on the supply roll to remove it from the right side of the
carrier
b. Set the supply roll aside.
Used Supply Roll
c. Lift up on the take-up roll to remove it from the left side of the
carrier.
d. Set the take-up roll aside.
e. Lift the print ribbon carrier off of the print ribbon and set it aside.
f. Discard the used print ribbon.
Used Take-Up Roll
2001431_C
All manuals and user guides at all-guides.com
For more information visit

Install the Print Ribbon

1. Remove the new print ribbon from the packaging.
2. Install the print ribbon on the print ribbon carrier.
Important! When you install the new print ribbon on the carrier, do not
rotate the ribbon past the black cleaning bars. When the new ribbon is
installed in the integrated Everest 400 printer, the ribbon advances and
the bars clean the print head.
a. With the supply roll on the right side, unwind several inches of the
new print ribbon.
b. Place the print ribbon on a clean, flat surface.
c. Place the print ribbon carrier on top of the print ribbon.
Tip: To keep the print ribbon carrier in place while you install the
print ribbon, position the carrier so that the tab rests on the edge of
a table or workspace.
New Take-Up Roll
Tab
rimage.com/support
New Supply Roll
17