Rimage Professional 3400 Bedienungsanleitung Seite 21

Change the Print and Retransfer Ribbons
d. Bring the supply roll up and around the tacky roller and guide rollers
on the right side of the carrier.
e. Press down to install the supply roll, as shown.
f. Bring the take-up roll up and around the guide roller on the left side
of the carrier
g. Press down to install the take-up roll, as shown.
Take-Up
Roll
Guide
Roller
h. Set the print ribbon carrier upright. The supply role should be at the
top of the carrier.
2001431_C
All manuals and user guides at all-guides.com
Supply Roll
Tacky
Roller
Guide
Roller
For more information visit
i. Rotate the take-up roll clockwise to tighten the ribbon. Make sure
that the ribbon is aligned and lies flat on the carrier.
Tips:
• You may need to lift the ribbon up from the tacky roller to
straighten it.
• Do not rotate the ribbon past the black cleaning bars at the
front of the ribbon.
• If you installed a black (monochrome) ribbon, advance the
ribbon so the ink portion of the ribbon is advanced to the take-
up roll.
Supply Roll
3. Reassemble the printer.
a. Slide the print ribbon carrier into the printer.
b. Turn the center latch clockwise to lock it.
c. Close the printer cover.
Tip: Ribbon color can vary from lot to lot. After you load the new
ribbon, you may need to adjust the density settings in the printer
Adjust the Print Alignment and Color Density
driver. Refer to the
section on page 15 for more information.
The printer is ready for use.
rimage.com/support
18