Operate Gemini Utilities; Start Gemini Utilities; Change The Autoloader Display Name; Enable The Beeper - Rimage Professional 3400 Bedienungsanleitung

Operate Gemini Utilities

Operate Gemini Utilities
The Rimage software includes an application called Gemini Utilities,
which is used to change the display name of the system and to enable the
beeper. Gemini Utilities is only available on the Professional 5400N and the
Professional 3400 running Rimage Network Software Suite.
Tips:
• To access Gemini Utilities for the 5400N, use the remote desktop
connection from a networked PC, or connect a monitor, keyboard, and
mouse to the 5400N.
• Unless otherwise indicated, all Windows navigation statements are
Windows 7 paths. Other Windows operating system navigation may
differ slightly.

Start Gemini Utilities

1. Close all open software applications and stop all Rimage Services.
Tip: Refer to your Rimage software online help for additional
information.
2. From the Windows Start menu select: All Programs >
Rimage > Utilities > Gemini Utilities. Gemini Utilities opens.
3. When the desired tasks are complete, start the Rimage Services.

Change the Autoloader Display Name

Use Gemini Utilities to enter the name displayed on the operator panel.
Important! Changing the display name does not change the name of the
system on a network or workgroup. To change the name on a network or
workgroup, refer to your setup and installation instructions or the Rimage
Advance Setup (Networking) Guide.
1. Select the Override Name checkbox.
2. Clear the Use Computer Name checkbox.
3. In the Display Name field, enter the new name.
4. Select Set Params to set the name.
The operator panel display name is set.
2001431_C
All manuals and user guides at all-guides.com
For more information visit

Enable the Beeper

You can change the number of beeps that occur when the unit is out of
media or when there is an error.
1. In the # of Beeps on Fault field, select the number of beeps you wish to
hear when there is an error.
Tip: To disable the beeper, set the number to zero.
2. Select Set Params to set the number of beeps.
The beeper is set.
rimage.com/support
27