Rimage Professional 5100N Einrichtungs- Und Installationsanleitung

Rimage Professional
5300N Setup and Installation Guide
Before you begin:
This document is intended for people who are familiar with hardware setup, software
installation, and Windows operating systems. If you do not understand the procedures
in this document, ask your computer technician for help.
This document describes how to set up your Rimage 5100N and 5300N. The 5100N
and 5300N are part of the Rimage Professional series of autoloaders.
For information about how to connect the system to a network, refer to the Advanced
Setup (Networking) Guide (110721) provided with your autoloader.
Documents referenced in this procedure shipped with your product and are also
available online at www.rimage.com/support. From the Support menu select:
Professional Series > Product Name > User Manuals tab.
-
Important!
• Read all setup instructions thoroughly before you begin.
•
Save all packing boxes and packing materials for your autoloader and printer.

Notes:
•
Your product may not look exactly like the product pictured.
• The terms "Professional" and "autoloader" are used throughout this document
to refer to the 5100N and 5300N.
•
Unless otherwise indicated, all Windows navigation statements in this
document are Windows XP paths. Windows 2000 and Windows Vista paths
may differ slightly.
# Required tools:
•
Scissors or side cutters
•
Phillips screwdriver
2000448_E Copyright © 2010 Rimage Corporation
™ 5100N and
1
Prepare the Professional
-
Important! Keep all packaging materials.
a.
b.
c.
d.
e.
f.
Tape
Foam
g.
Remove the tape from the
front door.
Remove the Software Protective
Agreement label from Foam
Strip
the front door.
-
Important! Read
the label before you
remove it.
Remove the protective
foam strip from the inside
of the door.
Remove the foam from inside the Professional (5300N only).
Remove the tape from input bin
(5100N only).
Remove the tape from the collator.
5300N 5100N
Tape
Remove the tape securing the Tape
printer cords on the back of the
Professional.
2
Prepare the Everest printer
a. Unpack the Everest
printer. Refer to the label
on the Everest printer box.
b. Follow the instructions on
the instruction card on the
rear of the printer.
Set the AC voltage
i.
switch.
Tape
ii. Move the shipping
screw to the storage
position.
c. Open the Everest printer.
Software
Agreement
i. Press the two side cover
Label
latches.
ii. Lower the side cover.
d. Open latches 1, 2, and 3 as
indicated by the arrows.
e. Remove the plastic packing
pieces (2) from inside the
printer.
Plastic Packing Pieces
3
Set up the Everest printer
a. Place the printer on the
Professional so that the feet
slide into the slots on the
printer plate.
n
Caution: Lift the Everest
printer with care; it is
very heavy.
b. Connect the printer cables.
i. Connect the power cord
from the Professional to
the printer.
ii. Connect the printer
cable to the printer.
iii. Connect the USB cable
to the printer.
Voltage Switch
Shipping
Screw
Instruction
Storage
Card
Position
Shipping Screw
Side Cover
Latches
Latch 1
Latch 2
Latch 3
Printer Plate
Slots
Printer
Cable
USB
Cable
Power
Cord
Page 1