Zeiss Stemi 305 cam Bedienungsanleitung Seite 121

ZEISS
FCC Statement for Stemi 305 cam
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution:
Changes or modifications not expressly by party responsible for compliance could void the user's
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
−
Reorient or relocate the receiving antenna
−
Increase the separation between the equipment and receiver
−
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
−
Consult the dealer or an experienced radio/TV technician for help
RF-exposure Statement for Stemi 305 cam
The device has been evaluated to meet general RF exposure requirement. The Device can be used in portable
exposure conditions without restriction. Changes or modifications not expressly approved by party responsible for
compliance could void the user's authority to operate the equipment.
Caution:
This device was tested for typical body-worn operations. To comply with R&TTE exposure requirements, a
minimum separation distance of 10 mm must be maintained between the user's body, including
antenna. Third-party belt-clips, holster and similar accessories used by tis device should not contain any
metallic components. Body-worn accessories that do not meet these requirements may not comply with
RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
Max. SAR measurement (10 g) Head/Body: 6.2 µW/Kg
Appendix to user manual Stemi 305 cam, Version 5 from 03/2015
APPENDIX
Appendix to user manual
Stemi 305 cam stereo microscope
(SAP 435063-9044-008)
Stereo microscope
Stemi 305 cam
page 1 of 1