Cleaning; Service; Disposal - Gram PLUS Bedienungsanweisung

Cleaning
The cabinet should be cleaned internally with a mild soap solution at suitable
intervals and checked thoroughly before it is put into operation again.
For the external maintenance - use stainless steel polish.
Cleansing agents containing chlorine or compounds of chlorine as well as other
corrosive means, are not to be used, as they might cause corrosion to the stainless
panels inside the cabinet and the evaporator system.
The compressor compartment and in particular the condenser must be kept free from
dust and dirt. This is best done with a vacuum cleaner and a brush.
Do not flush compressor compartment and evaporator with water as this may cause
short-circuits in the electrical system.
NB!: Always disconnect the cabinet before cleaning.
Service
The refrigerating system and the hermetically sealed compressor require no
maintainance - other than the filters on the unit cover and condenser being removed
and washed regularly. The unit cover hinges open with the filter head by velcro in the
cover and springs on the condenser.
If refrigeration fails, first look to see whether the cabinet has been unintentionally
switched off, or whether a fuse has blown. If the cause of failure cannot be found,
contact your supplier quoting TYPE, PART NO and SER. NO of the cabinet. This
information can be found on the nameplate which is situated on the inside top right
hand corner.
Disposal
If the cabinet for which there is no longer any use is to be disposed of, please do so
in an environmentally correct way. There might be special requirements/conditions to
be observed.
Nameplate
Made in Denmark
Type
Part no.
Serie riD.
Prod. no.
Permissible operation over-pressJ-e: S u e
€JM*AJVM
Climate class
Volt Hz
Watt
Watt Heating element
Refrigerant gr
tim side: Disclarge side:
76-504-0930 19