GUTMANN FLOTAR 9200EM Bedienungsanleitung Seite 19

EN
Activated carbon filter
Please note that the activated carbon filters used in this hood type are disposable acti-
vated carbon filters. These have to be replaced with new ones after a decreasing func-
tion or deterioration of the indoor air quality.
Transport, unpacking, installation
Condensation may occur if the appliance is brought
into the installation site from a cold environment. Please wait until the appliance has
adjusted to the temperature and is completely dry before operating it. The acclimatizati-
on period depends on the temperature difference and the type and design of the appli-
ance. However, it should be at least 12 hours.
Connection to power supply
Check that the rated voltage of the device corresponds to the local mains voltage. In-
correct setting will damage or destroy the device.
Before operation, check whether all cables and wires are faultless and undamaged. In
particular, make sure that the cables are not bent, have not been laid too short around
corners and that there are no objects on the cables. Furthermore, make sure that all
plug connections are tight. Faulty shielding or wiring endangers your health (electric
shock) and can destroy other equipment. Devices with a mains plug are equipped with
a safety-tested mains cable from the country of use and must only be connected to a
properly earthed earth contact socket, otherwise there is a risk of electric shock. Make
sure that the socket at the device or the earth contact socket of the house installation is
freely accessible so that the mains cable can be disconnected from the socket in an
emergency or during service or maintenance work.
Danger of electric shock !
Do not clean the hood with a steam cleaner or water pressure. When cleaning
the hood, it must first be disconnected from the power supply.
Design
From an aesthetic perspective, the extractor hood may differ from the drawings in the-
se operating instructions. However, the operating instructions, maintenance, cleaning
and installation procedures are always the same. The drawings and plans must be
consulted in the case of customer-specific products.
19