Maintenance - Ferm CDM1140 Bersetzung Der Originalbetriebsanleitung

Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Machine
2. Battery indication light
3. Work light button
4A. Counterclockwise switch
4B. Clockwise switch
5. Base cover
6. Work light
7. Bit holder
8. Screwdriver bit
9. Base
10. Charging socket
3. OPERATING
The machine must be charged before
first use.
Charging the machine
Fig. B
In order to charge the machine, insert the
small micro-USB plug of the charger cable
into the charging socket (10) on the side of
the machine (1). Subsequently plug the large
USB plug connector into a USB outlet. The
battery indication light (2) will show the charging
progress.
Fully charging the battery may take up to 70-90
minutes.
Fitting and removing drills or screwdriver bits
Fig. C
The machine bit holder (7) is suitable for drills
and screwdriver bits with a standard 1/8" (4mm)
hexagonal shaft. To fit a screwdriver bit:
• Insert the screw driver bit (8) into the machine's
bit holder (7), it will be hold by a magnet.
• The screw driver bit can be removed by pulling
it out of the bit holder again.
8
Switching the machine on and off
Fig. A
• Pressing the Counterclockwise switch (4A) will
activate the machine to loosen screws.
• Pressing the Clockwise switch (4B) will
activate the machine to tighten screws.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
Work light button
Fig. A
• Press the Work light button (3) once to turn the
work light on.
• Press the on/off switch (3) again to turn the
work light off.
Spindle lock function
The machine is fitted with an automatic spindle
lock feature. When the on/off switch is not
pressed, the bit holder (7) rotation is locked. Now
it is possible to use the screwdriver (even when
the battery is empty) as a manual tool.

4. MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.