Residual Risks; Machine Information; Technical Specifications - Ferm CDM1140 Bersetzung Der Originalbetriebsanleitung

d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
For the charger
Intended use
This screwdriver has an integrated lithium-ion
battery, which you can charge with the included USB
charging cable (USB-mains adapter not included).
a) The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
b) Children being supervised not to play with
the appliance
c) Do not recharge non-rechargeable batteries!
d) During charging, batteries must be placed in a
well ventilated area!
e) Integrated batteries may only be removed
for disposal by qualified personnel. Opening
the housing shell can destroy the power tool.To
remove the battery from the power tool, press the
On/Off switch until the battery is fully discharged.
Unscrew the screws on the housing and remove
the housing shell in order to remove the battery.
To prevent a short circuit, disconnect the
connectors on the battery one at a time and then
isolate the poles. Even when fully discharged, the
battery still contains a residual capacity, which
can be released in case of a short circuit.

Residual risks

Even when the power tool is used as
prescribed it is not possible to eliminate all
residual risk factors. The following hazards
may arise in connection with the power tool's
construction and design:
a) Health defects resulting from vibration
emission if the power tool is being used
over longer period of time or not adequately
managed and properly maintained.
b) Injuries and damage to property to due to
broken accessories that are suddenly dashed.
Warning! This power tool produces an
electromagnetic field during operation.
This field may under some circumstances
interfere with active or passive medical
implants. To reduce the risk of serious or
fatal injury, we recommend persons with
medical implants to consult their physician
and the medical implant manufacturer
before operating this power tool.

2. MACHINE INFORMATION

Intended use
This screw driver is intended for driving in and
loosening screws.

Technical specifications

Model No
Output of charger
Rechargeable Battery pack
Battery charging time
Chuck capacity
No load speed
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screw driving without impact)
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN62841; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
CDM1140
5V DC Max. 1000mA
4V Li-ion 320 mAh
70-90 minutes
1/8" (4mm) hex
120 /min
39.5 dB(A) K=3 dB(A)
50.5 dB(A) K=3 dB(A)
0.149 m/s K=1.5 m/s
2 2
7