Disposal Information; Legal Information; Service Life - Ottobock Terra Gebrauchsanweisung

4) Allow to air dry.
7.3.2 Cleaning the foam base
1) Remove the foam base from the cover to clean it (see Page 18).
2) Use lukewarm water for cleaning. If necessary, an alcohol-free disinfectant or mild detergent
can be added.
3) Wipe the foam base with a damp cloth or sponge.
INFORMATION: When adding disinfectant or detergent, wipe the foam base with clear
water in a second step.
4) Dry the foam base with a towel, dab or let air dry at room temperature.
5) Avoid exposure to direct heat (e.g. sun or heat from radiators and stoves).
8 Maintenance
The function of the product should be checked before each use.
•
Check the product monthly for wear and tear and damage. The interval between inspections
•
should be further reduced for very heavy users.
- Check the cover for rips, holes and other damage.
- Verify that the zip is working properly.
- Remove dust and dirt particles from the cover's hook-and-loop strap.
- Check the foam base and, with the 476C00=SK65/8/9*, the LiquiCell
• Have damaged or worn parts replaced by qualified personnel as soon as possible.
• Service and repairs may only be carried out by authorised, qualified personnel or the manu­
facturer. This will ensure that only Ottobock spare parts are used for repairs.

9 Disposal information

Return the product to the specialist dealer for disposal.
All components of the product must be disposed of properly in accordance with the respective
national environmental regulations.

10 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
10.2 CE conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as class I accessories according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
10.3 Warranty
Further information on the warranty terms and conditions can be obtained from the qualified per­
sonnel that has fitted this product or the manufacturer's service (see inside back cover for
addresses).

10.4 Service life

Expected service life: 2 years.
®
packs for damage.
19