GRAPHITE 59G062 Betriebsanleitung Seite 20

rubber O-ring and this ring is not damaged. Also surfaces of the outer flange and the inner flange
must be clean.
• Use quick release flange only with cutting and grinding discs. Use only flanges that are free from
defects, that operate correctly.
• In case of temporary mains power failure or after disconnecting plug from mains socket with the
switch in ON position, unlock the switch and set it to OFF position before starting the tool again.
NOTE: The tools is intended for indoor works.
Despite using the construction, which is safe by design itself, protection means and additional safety
features, there is always a residual risk of injuries during operation.
Descriptions of used pictograms.
1 2 3
1. Warning, take special precautions.
2. Read the instruction manual, observe warnings and safety conditions included in it!
3. Use personal protection equipment (safety goggles, ear protectors).
4. Use safety gloves.
5. Disconnect the power cord, before maintenance or repair works are begun.
6. Keep out of reach of children.
7. Protect against rain
8. Protection class II
DESIGN AND APPLICATION
The angle grinder is a hand-held power tool with the II class isolation. The power tool is driven with a single-
phase, commutator motor, whose rotational speed is reduced by means of an intersecting axis gear. The
power tool can used both for grinding and cutting. This type of power tools is widely used for removal of
burrs from metal surfaces, weld surface processing, cutting light-wall tubes and other small metal objects
etc. They are used in engineering industry, automotive and chemical industry. With the use of proper tools,
the angle grinder can be used not only for cutting or grinding, but also for rust and paint coats removal.
The areas of its application include repair and construction works, not only related to metals. The angle
grinder can also be used for cutting and grinding of construction materials, such as brick, paving stones,
ceramic tiles, etc.
The power tool is designed for dry operation only and it must not be used for polishing. The power
tool should be used according to its purpose.
Use inconsistent with its purpose
• Do not work materials that contain asbestos. Asbestos is carcinogenic.
• Do not work materials, whose dust is inflammable or explosive. During operation, the power tool
produces sparks, which may ignite emitted vapours.
• Do not use cut-off wheels for grinding. The cut-off wheels are used to cut with its face, while grinding with
lateral surface of such a cut-off wheel threatens with its damages and puts the operate in danger of injuries.
DESCRIPTION OF GRAPHIC PAGES
The below list refers to device components shown in the graphic pages of this instruction manual.
1. Spindle lock button
2. Switch
3. Additional handle
4. Grinding wheel cover
5. External flange
6. Internal flange
* There can be differences between the drawing and actual product.
4 5 6
20
7 8