Installation (See Fig. A-C); Operation; Reaching The Decided Room Temperature; Turbo Heating - Silvercrest SOR 2400 D2 Bedienungs- Und Sicherheitshinweise

˜ Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward (see fig . A) .
Place the U shape castor assembly
over the U shape bolt
pointing upward (see fig . B) . Ensure both
threaded ends of U shape bolt
through both holes on the U shape castor
assembly .
11
Fasten wing nut
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins (see fig . C) .
Set the product back to upright position, wheels
on the floor . It is now ready to use .
Note: The product is equipped with a
tilt protection switch . It will shut down the
product automatically if it falls over or is
lying on its side .
˜ Operation
Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
"0" respectively .
321301_ES_RS_BG_02.indb 11
upper than
7
(see fig . A) .
3
to the product
10
11
with both wheels
10
passing
10
securely onto each
8
.
10
attached between
10
.
7
are set to MIN and
2
Connect the product to a grounded mains
socket protected by a residual current circuit
breaker . Ensure that the mains voltage of
the electrical outlet meets the requirements
described in the "Technical data" chapter .
Note: Ensure the mains plug is fully inserted
to the mains socket .
˜ Reaching the decided
room temperature
Set the temperature control
the heat level switch
indicator lights up .
1
When the desired room temperature is reached,
turn the temperature control
clockwise until the product shuts off, a "click"
sound is heard and the power indicator
goes off . Leave the temperature control
9
at the position and the room temperature is
now retained .
The product automatically cycles on and off
to keep the decided room temperature, the
power indicator
off to indicate when the product is heating
up . As long as the heat level switch
to "1"/"2"/"3", the product operates even
when the power indicator
Use the heat level switch
quickly the product shall warm up . To warm
up quickly, set the heat level switch
3
˜ Turbo heating
To heat the room more quickly, set the
temperature control
heat level switch
indicator lights up .
1
to MAX . and
3
to "3", the power
2
gently counter-
3
1
3
light also cycles on and
1
is set
2
is off .
1
to select how
2
to "3" .
2
to MAX . and the
3
to "3", the power
2
GB/CY
17/5/2019 3:35 PM
11