Installation; Operation; Reaching The Decided Room Temperature; Turbo Heating - Silvercrest SOR 2400 D2 Bedienungs- Und Sicherheitshinweise

Do not use this product near a
bathtub, shower or swimming
pool.
Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward, see fig. A.
Place the U shape castor assembly
the U shape bolt
pointing upward, see fig. B, ensure both
threaded ends of U shape bolt
through both holes on the U shape castor
assembly .
11
Fasten wing nut
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins, see fig C.
Set the product back to upright position, wheels
on the floor. It is now ready to use.
Note: The product is equipped with a tilt
protection switch. It will shut down the product
automatically if it falls over or is lying on its side.

Operation

Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
"0" respectively.
Connect the oil-filled radiator to a grounded
electrical outlet protected by a residual
current circuit breaker, see "Technical data"
chapter.
10 GB
upper than
7
, see fig. A.
3
to the product
10
over
11
with both wheels
10
passing
10
securely onto each
8
.
10
attached between
10
.
7
, are set to MIN and
2
Reaching the decided
room temperature
Set the temperature control
the heat level switch
indicator
1
When the desired room temperature is reached,
turn the temperature control
clockwise until the product shuts off, a "click"
sound is heard and the power indicator
goes off. Leave the temperature control
at the position and the room temperature is
now retained.
The product automatically cycles on and off
to keep the decided room temperature, the
power indicator
off to indicate when the product is heating
up. As long as the heat level switch
to "1"/"2"/"3", the product operates even
when the power indicator
Use the heat level switch
quickly the product shall warm up. To warm
up quickly, set the heat level switch
9

Turbo heating

To heat the room more quickly, set the
temperature control
heat level switch
indicator
1
Press the heating fan switch
"I" to switch on the heating fan. An indicator
in the heating fan switch
Hot air will be blown through the hot air
outlet .
5
To switch off the hot air outlet
heating fan switch
Using the temperature control
product to the desired temperature.
3

Switch off the product

Press the heating fan switch
to switch off the hot air outlet
to MAX. and
3
to "3", the power
2
lights up.
gently counter-
3
light also cycles on and
1
is off.
1
to select how
2
2
to MAX. and the
3
to "3", the power
2
lights up.
to position
4
will light up.
4
, press the
5
to "0" position.
4
to set the
3
to position "0"
4
.
5
1
3
is set
2
to "3".