Installation; Operation - Silvercrest SOR 1500 D3 Bedienungs- Und Sicherheitshinweise

Place the product on a level,
stable and heat resistant floor .
Do not place any open fire
sources, such as candles, on
the product .
Never block the ventilation
slots .
4
Do not use this product with a
programmer, timer, separate
remote-control system or any
other device that switches
the product on automatically,
since a fire risk exists if
the product is covered or
positioned incorrectly .
Do not use an extension cord .
Do not use this product in
rooms with a room volume of
less than 4 m
Only use accessories and
additional equipment
stated in the instruction
manual . The use of other
products or accessories
than recommended in the
instruction manual may
present a risk of injuries for
you .
20 GB/IE
.
3
Do not use this product
near a bathtub, shower or
swimming pool .
˜ Installation
Place the product upside down on a
soft underlay to avoid scratches on the
surface (see fig . B) .
Place a caster assembly
fixed on the front cover with both wheels
pointing upwards (see fig . B) .
Ensure both threaded ends of fixed bolts
are passing through both holes of the castor
assembly .
7
Fasten wing nut
6
threaded end of fixed bolts .
Attach the U shape bolt
between the last 2 fins with the threaded
ends pointing upwards (see fig . B) .
Place the castor assembly
shape bolt with both wheels pointing
8
upward, see fig . B . Ensure both threaded
ends of U shape bolt
both holes on the castor assembly
Fasten the wing nut
threaded end of U shape bolt
Set the product back to upright position, wheels
on the floor . It is now ready to use .
Note: The product is equipped with a tilt
protection switch . It will shut down the product
automatically if it falls over or is lying on its side .
˜ Operation
Unwind the power cord completely from the
power cord retainer
over both bolts
7
securely onto each
to the product
8
over the U
7
passing through
8
.
7
securely onto each
6
.
8
.
5