Sanus VMF408 Bedienungsanleitung Seite 12

3 Mount the Wall Plate
3-1 Locate studs and mark the wall
Verify the center of the stud(s) using an awl, a thin nail, or an edge to edge stud finder.
CAUTION:
Avoid potential personal injuries and property damage!
 Drywall covering the wall must not exceed 16 mm (5/8 in.)
 Minimum wood stud size: common 51 x 102 mm (2 x 4 in.) nominal 38 x 89 mm (1¹/2 x 3¹/2 in.)
 Minimum horizontal space between lag bolts: 41 cm (16 in.).
For assistance in determining wall plate location, see Height Finder at sanus.com.
Level the wall plate template, [01] and mark the hole locations.
3-2 Drill pilot holes and tighten lag bolts
CAUTION:
Avoid potential injuries or property damage! Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.)
diameter drill bit.
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
 DO NOT over-tighten the lag bolts [29].
 Tighten the lag bolts [29] only until the washers [28] are pulled firmly against the wall plate [03].
12
(Wood stud)