Installing The Drain Piping - Technibel CAFM255R5IA Bedienungsanleitung

2-4. Installing the Drain Piping

(1) Prepare standard hard PVC pipe for the drain and
use the supplied drain hose and hose band to
prevent water leaks.
The PVC pipe must be purchased separately.
The transparent part allows you to check drain-
age. (Fig. 2-6)
CAUTION
(2) After checking the drainage, wrap the supplied
packing and drain pipe insulator around the pipe.
(Fig. 2-7)
NOTE
Ensure the drain pipe has a downward gradient
(1/100 or more) and that there are no water traps.
CAUTION
If it is necessary to increase the height
of the drain pipe, the section directly
after the connection port can be raised
a maximum of 50 cm. Do not raise it
any higher than 50 cm, as this could
result in water leaks.
(Fig. 2-9)
Do not install the pipe with an upward
gradient from the connection port. It
will cause the drain water to flow
backwards and leak when the unit is
stopped. (Fig. 2-10)
Do not apply force to the piping on the
unit side when connecting the drain
pipe. The pipe should not be allowed
to hang unsupported from its connec-
tion to the unit. Fasten the pipe to a
wall, frame, or other support as close
to the unit as possible. (Fig. 2-11)
Provide insulation for any drain pipes
that are installed indoors.
Tighten the hose clamps
so their locking nuts face
upward. (Fig. 2-6)
Do not install an air
bleeder tubes, as this
may cause water to spray
from the drain tube outlet.
(Fig. 2-8)
Transparent part for
checking drainage
Packing Drain hose
(supplied) (supplied)
Drain insulator (supplied)
Air bleeder
Upward gradient
7
Hard PVC pipe
Hose band
(not supplied)
(supplied)
Drain hose
adapter
(supplied)
Fig. 2-6
0197_X_I
Fig. 2-7
0047_X_I
Fig. 2-8
30 cm or less (as short as possible)
50 cm or less
Fig. 2-9
0049_X_I
Fig. 2-10
Support
pieces
0050_X_I
Fig. 2-11
0964_X_I
2262_X_I