Using The Remote Control Unit - Technibel MCAF72R5TA Serie Bedienungsanleitung

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES
G
Remove the lid in the rear part of the remote control unit.
G Insert two AAA alkaline batteries of 1,5 V-DC.
Make sure the batteries point in the direction marked in the
battery compartment.
G The batteries last about six months. Depending on how much
you use the remote control unit.
Remove the batteries if you do not use the remote control unit
for more than one month.
Press the +, -, SET and CLEAR buttons together after batteries
replacement.
(This operation allows you to reset correctly all the programs.
The remote control unit is to be set up again).
Replace the batteries when the remote control unit lamp fails
to light, or when the air conditioner does not receive the remote
control unit signals.
G
The batteries of the remote control contain polluted substances
exhausted batteries must be disposed according to the laws
in force.
TEMPERATURE SENSOR SELECTOR
G
Under normal conditions the room temperature is detected and
checked by the temperature sensor placed in the air conditioner.
G
Press the remote control I FEEL button to activate the
temperature sensor placed in the remote control. This function
is designed to provide a personalised environment by transmitting
the temperature control command from the location next to you.
Therefore, in using this function, the remote control should
always be aimed, without obstruction, at the air conditioner.
NOTE
The remote control unit sends the
temperature signal to the air
conditioner regularly at two
minute intervals. If the signal from
the remote control unit stops for
more than five minutes due to
some troubles, the air conditioner will switch to the
temperature sensor which is built into the indoor unit and
controls the room temperature. In these cases, the
temperature around the remote control unit may differ from
the temperature detected in the air conditioner position.
REMOTE CONTROL UNIT
DISPLAY
5
OPERATION WITH THE REMOTE CONTROL UNIT
CAUTION
Check that the circuit breaker on the power panel is turned ON
and the the STANDBY lamp is light up.
When using the remote control unit, always point the unit
transmitter head directly at the air conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air conditioner on. The
indicator OPERATION will light up, indicating the unit is in
operation.
REMOTE CONTROL UNIT
INDOOR UNIT
RECEIVER
(TRANSMITTER HEAD)
EG