Setup; Connect Your Monitor To Your Computer; Connect The Power Cord - Sony GDM-FW9011 Bedienungsanleitung

Setup

This monitor works with platforms running at horizontal
frequencies between 30 and 121 kHz.
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• When connecting the video signal cable, check the alignment of the
connector. Do not force the connector in the wrong way or the pins
might bend.
x x x x Connecting to the HD15 connector
1 R
AC IN
To a computer with
an HD15 video output
6
G B HD VD 2
to HD15 input
video signal cable
(supplied with host computer)
x x x x Connecting to the five BNC connectors
1 R
AC IN
to R/G/B input
Refer to the preceding
examples to connect to your
computer.
* Connect the cables from left to right in the following order: Red-Green-
Blue-HD-VD.
Note
Plug & Play (DDC) does not apply to the five BNC connectors. If you
want to use Plug & Play, connect your computer to the connector using
the supplied video signal cable.
Step 2: Connect the power cord
With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
1 R
AC IN
to AC IN
power cord
G B HD VD 2
to HD/VD
input
video signal cable
(not supplied)*
G B HD VD 2
to a power outlet