ECG FS 40 R Bedienungsanleitung Seite 36

USE
Make sure prior to each use that the fan is in good condition and the power cord is not damaged. The appliance
must not be used when the power cord is damaged. The function of the fan can be controlled using either the
buttons on the control panel or the remote control. You have to point the remote control at the control panel.
Insert two AAA batteries into the remote control prior to use (AAA batteries not included). Pay attention to
correct polarity of the batteries.
Warning: Carry the appliance only by holding the fan body.
Ventilation:
1. Plug the fan into an electrical outlet and switch it on by pressing ON-SPEED button on the remote control
or on the panel of the device. The fan starts at lowest speed.
2. Select the desired speed by repeatedly pressing the ON-SPEED. The indicator of the control panel shows
the selected speed: LOW (minimal), MEDIUM (medium), HIGH (maximum).
3. To turn off the fan, press on the remote control or panel of the device the OFF button. Then unplug the
power cord.
Setting the fan mode
GB
Use the MODE button to set the fan mode
• NORMAL – the device runs according to current setting and constant fan rotations.
• NATURAL – the motor works automatically in alternating cycle of high – medium – low speed as shown
by the following diagram.
High
Medium
Low
High
Medium
Low
High
Medium
Low
36
Natural – high speed
Natural – medium speed
Natural – low speed
Time (s)
Time (s)
Time (s)