How To Use The Appliance - Concept CW 1000 Bedienungsanleitung

OPERATING INSTRUCTIONS
B
EFORE FIRST USE:
1. Carefully remove all contents from packaging and inspect the product for damage.
2. Assemble the appliance as per the instructions.
3. Charge the product for 4 hours.
4. Your appliance is now ready for use.
Dispose of the packaging in a responsible manner.
CHARGING
Before first use, charge the product for 4 hours.
The window vacuum needs to be charged for 4 hours for 30 minutes of continuous use.
How to charge:
1. Connect the lead from the charger to the charging port (11) on the window vac.
2. Plug the charger into the mains. During charging the indicator (10) will light red. When the window
vac is fully charged, the indicator will light green.
3. Remove the charger from the mains and the connector from the window vac.
Note: If the indicator is flashing, the window vac is not charging, press the power button (8) to reset the window
vac.
ASSEMBLY
1. Put the squeegee vacuum head (1) on the main body. An audible click will be heard, when it is in place.
2. Use the velcro to attach the microfibre cloth (7) on the squeegee vacuum head.

HOW TO USE THE APPLIANCE

1. Wipe the front edge of the squeegee (1) to remove any impurities.
2. Remove the clean water tank cap (3) and fill the tank with water using the water jug. Make sure not to
overfill. You can add a small amount of window cleaning solution.
3. Pull trigger (9) to spray the solution on a window and wipe any excess dirt with the cloth.
4. Turn the window vac on by pressing the power button (8).
5. Move the window vac vertically from the top to the bottom of the window, until the window is
clean.
6. Hold the window vac at the bottom of the window to suck any excess dirty water.
7. Turn the window vac off when the dirty water tank (12) is full.
8. Open the dirty water tank cap (6) and pour the content away.
Note: Always unplug the window vac from the charger before assembly, cleaning or maintenance.
C W 1000
EN
3 5