Monacor ATS-80R Bedienungsanleitung Seite 12

"Mode" and the operating mode set.
Select the mode desired by means of the
buttons /
 
3) Press the button
selected. The selection mode will be exited;
the rectangle (e) on the right side of the
display will show the first character of the
mode selected.
The receivers will automatically change to
the operating mode as soon as they are
set to the same transmission channel as the
transmitter (chapters 4.3 and 4.4).
4.3 Setting the transmission channel
Always observe chapter 1.1 when selecting
the transmission channel.
As long as the symbol
display, the channel selection is locked. To
unlock, press the buttons
at the same time until the symbol
out. Then immediately select the channel
by means of the buttons
selection will be locked 1 second after the
channel has been selected.
Automatic transfer of the transmission
channel to all receivers
1) Switch off the transmitter and set the se-
lector switch "s / m" (5) to the position "m".
2) Keep the talk button
(9) pressed to switch the transmitter on
again. The channel number will flash on
the display.
3) Use the buttons
transmission channel and then press the
button to confirm your selection or
wait for 5 seconds. The status indicator
(4) will flash rapidly and the talk button
will light up in green; the transfer of the
transmission channel to the receivers has
been activated.
4) All receivers must have been switched off.
When the receivers are switched on again,
they will automatically be set to the oper-
ating mode and transmission channel of
the transmitter.
5) Exit the transfer mode on the transmitter:
Either use the talk button
the normal mode or use the button
switch off the transmitter.
12
.
to confirm the mode
(d) is shown on the
and

/ . The channel
 
(10) and the button
/ (8) to select the
 
(10) to go to
4.4 Creating a group of a transmitter
and receivers
When a group consisting of a transmitter
and all receivers is created, the following
additional features will be available:
1. Presence check: By the press of a button,
the group leader can check how many
receivers are switched on and thus if all
members of the group are present.
2. Call signal: By the press of a button, the
leader of the group can send a signal to
all members (e. g. to ask the group mem-
bers to gather).
3. When a group member leaves the recep-
tion range, a warning signal will sound at
the corresponding receiver.
To create a group:
1) Switch off the transmitter and all receivers.
(8, 18)

goes
2) Set the selector switch "s / m" (5) on the
transmitter to the position "m".
3) Keep the red call button (11) and the but-
ton
ter. On the left side of the display, a chain
symbol will be shown; on the right side,
the channel number will start flashing.
4) Use the buttons
transmission channel and then press the
button
for 5 seconds. The status indicator (4) will
flash rapidly; the group creation function
has been activated.
5) Switch on all receivers of the group.
6) The display will show the number of re-
ceivers switched on. If the number is cor-
rect, exit the group creation mode on the
transmitter: Either use the red call button
(11) to go to the normal mode or use the
button
4.5 Connecting microphone / earphone
Putting the unit around your neck
1) Connect the earphone / microphone set
supplied to the jack (3) of the transmitter.
Put the earphone on your ear and align the
microphone in such a way that it is close
to your mouth.
to 2) Connect the earphone supplied to the jack
(14) of the receiver and put it on your ear.
(9) pressed to switch on the transmit-
/ (8) to select the
 
to confirm your selection or wait
to switch off the transmitter.