Service Information; 12 Vdc Automotive Cable Fuse Replacement - Stryker SMRT 6500 Bedienungs- Und Wartungshandbuch

12 VDC AUTOMOTIVE CABLE FUSE REPLACEMENT

Tools Required:
• None
Procedure:
1. Unplug the adaptor cable from the source and the charger.
2. Unscrew the tip on the source end and remove the fuse as shown in
Figure 13.
Note: The source tip and the fuse tension spring are loose and could be
dropped.
3. Install the new 10A 250V fuse into the source end of the adaptor cable and
screw the tip back on.
4. Plug both ends back in to the source and the charger.
5. Test the charger for functionality before returning to service.
Plug Connector (Charger)
www.stryker.com

Service Information

Figure 13: 12 VDC Automotive Cable
6500-109-105 REV A
Plug (Source)
Return To Table of Contents
1-33
English