Charging The Battery - Stryker SMRT 6500 Bedienungs- Und Wartungshandbuch

CHARGING THE BATTERY

Note:
• For extended storage, the SMRT Pak should remain on the SMRT Charger
to trickle charge and ensure that the SMRT Pak remains fully charged. The
SMRT Charger keeps the SMRT Pak charged and ready for use.
• The SMRT Pak should be at room temperature, within the allowable
temperature charge range of 43°F to 88°F (6°C to 31°C). Charging the SMRT
Pak outside of this recommended temperature range reduces SMRT Pak life
and extends charge time.
WARNING
If the SMRT Pak is cracked or damaged, do not insert it into the SMRT Charger.
Return damaged SMRT Paks to a service center for recycling.
To charge the SMRT Pak:
1. Insert a clean, dry SMRT Pak into the SMRT Charger. Make sure that the
SMRT Pak is properly seated. The SMRT Pak locks into the SMRT Charger.
2. The SMRT Charger indicator LED will flash green while charging. The
optimum charge time is two hours.
3. When the SMRT Pak is fully charged and ready, the charger indicator LED
turns to solid green, as shown in Figure 7.
4. Press the RED release button (Figure 7) and slide the SMRT Pak to release
the fully charged and ready SMRT Pak from the SMRT Charger.
GREEN (Flashing): Charging
GREEN (Solid): Charged & Ready
Figure 7: SMRT Charger Green Indicator LED
www.stryker.com
Charger Operation
LED Status
6500-109-105 REV A
RED
Release
Button
Return To Table of Contents
1-21
English