Battery Operation; Battery Considerations; Replacing The Battery; Storing The Battery - Stryker SMRT 6500 Bedienungs- Und Wartungshandbuch

BATTERY CONSIDERATIONS

• Fully charge all SMRT Paks prior to use.
• Replace a discharged SMRT Pak with a fully charged and ready SMRT Pak.
• Remove the SMRT Pak from the Power-PRO cot or SMRT Charger before
cleaning.
• The SMRT Pak is sealed and can be power washed separately. See
page 1-25 for cleaning instructions.

REPLACING THE BATTERY

WARNING
To reduce the risk of electric shock, do not remove the SMRT Pak when the
Power-PRO cot is activated.
The Power-PRO cot indicator LED flashes amber when the SMRT Pak needs to
be recharged or replaced. However, the SMRT Pak can be removed and charged
at any time. The SMRT Charger properly manages charging regardless of the
SMRT Pak charge state.
The
SMRT Pak can remain on the Power-PRO cot between service calls for up
to one week or until the cot indicator LED flashes amber.
CAUTION
Make sure that the SMRT Pak is fully charged prior to placing it into service. An
uncharged or depleted SMRT Pak may cause poor cot performance.
The Power-PRO cot indicator LED is solid green when the SMRT Pak is fully
charged or has adequately charged battery power.

STORING THE BATTERY

All batteries lose charge during storage or periods of inactivity. A SMRT Pak can
lose up to 30 percent of its charge within 48 hours after being removed from the
SMRT Charger. Stored SMRT Paks should be used and fully charged every three
months to maintain top performance.
www.stryker.com

Battery Operation

6500-109-105 REV A
Return To Table of Contents
1-23
English