Sharp SJ-F2560EVA-EU Bedienungsanleitung Seite 13

CHAPTER -3: USING YOUR FRIDGE FREEZER
Important Note: To prevent incorrect operation, the key lock must be deactivated.
Open the key lock: When the start button is pressed for the first time, the start and ready LEDs will light up. After
this activation process, the start button should be pressed again. The key lock will engage again, if no operation
is performed into 2 minutes.
4. When the vacuuming process is complete, a LED will light on the display. The vacuum bag can then be removed
from the compartment. (Figure 3).
VacPac Pro Working Process
5. After pressing the button, the mechanism moves up and starts to compress the bag. The ready LED will light.
6. After the bag is compressed, the vacuum process is commenced by the vacuum pump. The vacuum LED will light.
7. When the system reaches its intended vacuum limit, resistance starts to melt the mouth of the bag. The seal LED
will light.
8. After the sealing process is complete, the mechanism moves down and the seal done LED will light. As the motor
returns to the first position, the done LED goes out and the process is complete.
• All lights are turned off for 1 minute after the process is completed, during this time the system cannot be
activated.
• When the start and ready lights switch on, the system is ready for use again.
Cancelling Process:
• If you require the vacuum process to be canceled (except the sealing stage), press the start button for two
seconds.
• The Start LED goes off when the process is cancelled.
EN -11-