Advanced Programming - V2 CU1 Bedienungsanleitung

PROGRAMMING OF THE FUNCIONTS BY
MEANS OF TRANSMITTERS OF THE RANGE
ADLER
Using a transmitter of the range DUO it is possible changing the
functions of the control unit controlling the tubular motor.
QUICK transmitter recording
To record remote controls for a new control unit that drives a
shutter or a sunshade (NOT with casing) proceed as follows:
CAUTION: the first transmitter recorded determines the direction
of the motor's movement.
1. Power only the control unit to be programmed
2. Press and hold down UP and DOWN until the motor starts to
move in a direction
3. Release the buttons: the motor will stop
4. Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction
acquired: the UP button raises the roll-up shutter, the
DOWN button lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the roll-up shutter, the
UP button raises the roll-up shutter
5. End of programming
To add other remote controls, proceed as follows:
6. Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
7. Release the buttons: the motor will stop
8. Press the UP or DOWN button on the new remote control
CAUTION: If the sunshade has a casing, record the first remote
control by following the procedure "1. Record the transmitters
and select the sunshade mode"
UP
STOP
DOWN
10

ADVANCED programming

To perform ADVANCED programming it is necessary to remove
the cover plate of the remote control and carefully follow the
dedicated procedures for the various functions.
Each function can be selected by entering a code during the
programming procedure; following is a summary table of the
functions with their relative programming codes.
CODE
FUNCTION
A B C
12 11 11 Storage of the transmitters
12 11 13 Deletion of all the stored transmitters
Storing of the level of intervention of the
12 11 17
wind sensor
Programming of the level of intervention of the
12 11 18
sun sensor
12 11 21 Programming of the level of temperature
A: Code to activate programming
B: Indicates channel 1 of the remote control; for channel 2 the number
is 12, for channel 3 the number is 13, etc. up to channel 6
C: Code of the function to be programmed
The pictures that follow include references to the buttons and the
LEDs used during programming.
UP
STOP
DOWN
PROG