Items Supplied; Important Notes; Proper Use; Safety Regulations - EINHELL DKS 405 Bedienungsanleitung

Anleitung DKS 405
1. Description (Fig. 1)
6. Cover, left
12. Locking screw
13. Angle adjustment facility
14. Saw table
18. Blade holder, bottom
23. Retention clip
26. Blade guard
28. Hose
29. Holder
31. Blade holder, top
39. Clamping screw
41. Blade
49. Copper tube

2. Items supplied

Fretsaw
Blade guard
Sawdust blower facility
Standard blade
Operating instructions

3. Proper use

Assemble the fretsaw as described in Section 6.2
„Assembly". You are to use this fretsaw only to saw
squared timber or wood-type materials. To cut round
materials you must use suitable holding devices.
The machine is to be used only for its prescribed
purpose.
Any use beyond that mentioned after is considered
to be a case of misuse. The user/operator and not
the manufacturer shall be liable for any damage or
injury resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
06.11.2001 11:25 Uhr Seite 9
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Harmful emissions of wood dust when used in
closed rooms.
Contact with the blade in the uncovered cutting
zone.
Injuries (cuts) when changing the blade.
Crushed fingers.
Kickback.
Tilting of the workpiece due to inadequate
support.
Touching the blade.
Catapulting of pieces of timber and workpieces.

4. Important notes

Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.

Safety regulations

Important: Whenever you use electric tools it is
imperative to take basic safety precautions in
order to reduce the risk of fire, electric shock and
personal injury. Essential safety precautions
include:
In an emergency, switch off the machine directly
and pull out the power plug.
Follow all these instructions before and while
you are working with the saw.
Keep these instructions in a safe place.
Always pull out the power plug before adjusting
or servicing the machine.
Give these safety regulations to all persons who
work on the machine.
Do not use this saw to cut fire wood.
Never use the saw to cross -cut round timber
unless it is equipped with a suitable holding
device.
The machine is equipped with a safety switch to
prevent it being switched on again accidentally
after a power failure.
Before you use the machine for the first time,
check that the voltage marked on the rating plate
is the same as your mains voltage.
If you need to use an extension cable, make sure
its conductor cross-section is big enough for the
saw's power consumption. Minimum cross-
section: 1 mm 2 .
GB
9