AEG dvd 4502 Bedienungsanleitung Seite 28

5....-05-DVD 4502 AEG GB
General Setup
Select GENERAL SETUP in the SETUP MENU and then
select the desired option using the cursor buttons to navi-
gate through the menus/screens and press the ENTER
button to select.
1. Set up the TV DISPLAY
NORMAL/PS: Pan scan. Select when the unit is connec-
ted to a conventional TV. Video material formatted in the
Pan Scan style is played back with the left and right ed-
ges are cut off.
NORMAL/LB: Letter Box. Select when the unit is connec-
ted to a normal TV. Wide-screen images are shown on
the screen with a black band at the top and bottom.
WIDE: Select when the unit is connected to a wide-
screen TV.
Note:
The displayable picture size is preset on the DVD disc.
Therefore the playback picture of some DVD discs may
not conform to the picture size you select.
2. Set up ANGLE MARK
– Some DVD disc is record by serval video camera from
the different angles to take, when playback, can select
the one of the angle to watch.
ON open the angle
OFF close the angle
– The disc must have the angle mark, the set up can
work.
3. Set up the OSD LANG
– You can select the TV display language.
28
21.04.2004 8:54 Uhr Seite 28
4. Set up CAPTIONS
ON – open the option.
OFF – close the option.
The TV set must support closed captions function.
5. Set up SCR SAVER
– When no disc or playback stop some time, the unit will
automatic open the Screen saver function. This time
the screen will become black, only the DVD patten
move on the screen. This function is protect the TV
screen long time display will be hurt.
Speaker Setup
• Press UP/DOWN button to select the SPEAKER
SET UP and press ENTER.
– The left is the main catalog, the right is the children
catalog.
• Press LEFT/RIGHT button to enter the children cata-
log and press ENTER to confirm.
1. Set up the DOWNMIX MODE
– LT/RT When the playback disc with the PROLOGIC
DOLBY stereo , select this item, through this unit 's
decode system, you can enjoy effect in your room si-
miliar the movie theater with two front speaker.
– STEREO When sources is two channel, the audio
output is the common stereo signal. When sources is
5.1 channel, only output the left and right 2 channel
signal.
– OFF close the DOWNMIX and active the 5.1channel
manual.
When active 5.1 channel manual. You may control
CENTER, REAR, SUBWOOFER SPEAKER ON/OFF
and CENTER/REAR SPEAKER delay time. TEST TO-
NE may check the all speaker connect properly.