Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Betriebsanleitung/Operating manual
F3301/F33C1/F33S1
1.2
General dangers if the safety instructions are not followed
Load cells made by tecsis are manufactured in accordance with the lat-
est state of technology and are safe during operation. However, the
load cells can be the source of residual danger if they are used or op-
erated improperly. Any person who is entrusted to install, start up, main-
tain or repair a load cell must have read and understood the operating
instructions, particularly the technical safety instructions.
1.3
Residual dangers
The performance and scope of delivery of the load cell only cover a sub-
area of force measuring technology. The technical safety aspects of
force measuring technology must also be planned and implemented by
the system planner / equipper / operator in such a way that residual
dangers are minimised. The existing regulations must be complied with.
Residual dangers associated with force measuring technology must be
pointed out.
The following symbols are used in these operating instructions:
!
1.4
Ban on unauthorised changes and modifications
The load cell must not be modified from a structural or technical safety
point of view or opened without the express permission of tecsis. Any
modifications cancel our liability for any resulting damage.
1.5
Qualified staff
These load cells must only be used by qualified staff in accordance with
the technical data in connection with the safety requirements and regu-
lations mentioned in the following. The legal and safety require-ments
for the respective application must also be observed. This also applies
to the use of accessories. Qualified staff are persons who are familiar
with the installation, assembly, start-up and operation of the product
and have the qualifications to carry out their work.
24
Danger
Note
BD_BE_973 b
www.tecsis.de
Werbung
Inhaltsverzeichnis
