Functional Aspects Not To Be Mistaken For Anomalies - Olimpia splendid UNICO TWIN MASTER Hinweise Für Die Verwendung Und Pflege

Warnings signalled during normal operation should not be interpreted as anomalies.
LED A: indicates the filter may need cleaning
the led must be switched off manually after such operation.
leD B steady light: high battery temperature signal.
LED A + LED C flashing: continuous pump operation.
if the SPlit unit malfunctions, the UniCo can be run temporarily on its own. to clear the alarm status and
enable the UniCo unit on its own, proceed as follows: cut the mains voltage to both units, wait a few seconds,
and then reconnect the power line to the UniCo unit only.
once the SPlit is working correctly again, simply power it again and it will be detected by UniCo.
5.6.3 -

FUNCTIONAL ASPECTS NOT TO BE MISTAKEN FOR ANOMALIES

the following events may occur during normal operation:
a. The compressor does not start up again immediately after a stop (it takes about three minutes
to start again).
- in the operating logic of the appliance a delay between a compressor stop and its successive restart
has been included, so that the compressor itself is protected against activations that are too frequent.
b. During the heating operation of the heat pump appliances, the flow of hot air may occur some
minutes after activation of the compressor.
- Should the fan start at the same time as the compressor, for the first few minutes it would emit cold
air into the room (and this could bother the occupants) since the unit has not yet reached steady
running conditions.
EN - 31
UNICO TWIN