Timer Activation And Deactivation; Diagnosis, Alarms And Inconveniences; Diagnosis Of The Inconveniences; Running Tests And Troubleshooting - Olimpia splendid UNICO TWIN MASTER Hinweise Für Die Verwendung Und Pflege

6.5.3 - TIMER ACTIVATION AND DEACTIVATION

once set, the timer programs can either be activated or deactivated depending on occasional needs.
activation may relate to one of the two programs or both.
in particular, each time you press key B9 (Set timer) (Programs activation), situation changes as follows:
• Use of Program no. 1 only.
• Use of Program no. 2 only.
• Use of Programs 1 and 2.
• Disuse of both programs.

6.6 - DIAGNOSIS, ALARMS AND INCONVENIENCES

6.6.1 -

DIAGNOSIS OF THE INCONVENIENCES

it is important for the User to distinguish between functional problems and anomalies in relation to the be-
haviour of the appliance as foreseen for its normal operation.
furthermore, the most common problems may easily be solved through simple operations on behalf of the
User (See paragraph: anomalies and solutions).
For all the other reports (see paragraph: 6.6.2), it is necessary to always contact
the technical assistance service"
Any attempt to repair the appliance by unauthorised personnel will immediately
invalidate any form of guarantee.
6.6.2 -

RUNNING TESTS AND TROUBLESHOOTING

the air conditioner is able to perform a short self-diagnostics cycle in order to check for the normal operation
of the internal components.
to activate the self-diagnosis function, proceed as follows:
- Power the appliance by inserting the plug or using the system's disconnect switch;
- ensure that the machine is in stand-by (no leDs lit on the console);
- Press the micro key located under the cover on the right-hand side of the SPlit unit for at least 10
seconds. a beeper indicates the self-diagnosis function is activated.
at this point, "88" is displayed on the console and, at the same time, leD1 and leD2 are switched on.
The code " At" is subsequently displayed and then the machine configuration appears for 5 seconds.
Ce : if compensation is active
Cd : if compensation is not active
the true self-diagnostics function starts at this point.
if, during the self-test phase, the alarms related to the temperature and internal fan probes activate, the
function is promptly interrupted and the alarm code remains active on the visualization console.
Setting the electronic controller for installation at the top of the wall causes an automatic adjust-
ment of the ambient temperature of 3°C.
EN - 41
UNICO TWIN